Name |
Spezifikationen |
Modell-Nr.
|
STC-GEC33OX |
Bildsensor |
1/3” Interline VGA color progressive CCD: ICX424AQ
|
Gesamtanzahl der Bildelemente
|
692 (H) x 504 (V) |
Aktives Bildelement |
VGA: 648 (H) x 494 (V) |
Chipgröße |
5.79 (H) x 4.89 (V) mm |
Zellgröße |
7.4 (H) x 7.4 (V) µm |
Scansystem |
Progressive |
Vertikale Frequenz (Bildfrequenz)
|
89.91172 Hz at full resolution
0.72028 to 360.33325 Hz adjustable via the communication
Max. frame rate depends on the AOI setting
Max. frame rate of the camera (360.33325 Hz) is 104 vertical resolution AOI setting
|
Horizontale Frequenz |
47.2028 kHz |
Pixelfrequenz |
36.818175 MHz |
Geräuschpegel |
- |
- @ 8Bit-Ausgang |
≤ 3 Digit (Gain 0 dB) |
- @ 10Bit-Ausgang |
≤ 12 Digit (Gain 0 dB) |
- @ 12Bit-Ausgang |
≤ 48 Digit (Gain 0 dB) |
Minimale Beleuchtungsstärke |
25.75 Lux at F1.2, 89.91172 Hz |
Sync-System |
Internal |
Videoausgang |
Digital 8, 10 or 12 bit Raw Data
or RGB 8 bit
|
Schnittstelle |
PoE : IEEE802.3af CLASS3 (1000BASE-T) |
Protokoll |
GigE Vision® 1.2 and GenICam™ 2.0 |
Belichtungszeit
|
Preset continuous mode: 10 useconds to 16,777,216 useconds
Preset trigger mode: 10 useconds to 16,777,216 useconds
Pulse width mode: 10 useconds to Unlimited
|
ALC (Automatische Lichtkompensation) |
Auto iris lens, electronic iris and AGC (ON / OFF) |
Verstärkung |
0 to 20.4 dB |
Gamma |
Gamma 1.0 (Factory default) or downloadable gamma table |
AOI-Funktion (Area of Interest-Arbeitsgebiet) |
Programmable AOI setting via the communication |
Smear-Effekt Reduzierung |
Selectable ON / OFF via the communication |
Farbinterpolation |
Available on RGB output |
Weißabgleich
|
Auto, manual and push-to-set white balance is available on both Raw data output and RGB output |
Eingang / Ausgang
|
Three opto-isolated inputs and five opto-isolated outputs |
Auto-Blenden-Objektivsteuerung |
DC IRIS control input with video level target, peak/average and zone weight settings via the communication
|
Strom (Ampére) |
- |
- Eingangsspannung |
+10.8 to +26.4 Vdc through power/IO connector or Power Over Ethernet (Auto detection with power/IO connector prioritized)
|
- Verbrauch |
< 6.5 W (when user configurable FPGA is working) |
Trigger-Modus
|
Edge preset trigger, Pulse width trigger (unlimited long exposure) |
Kommunikation |
UART Communication through Ethernet port |
Benutzerkonfigurierbares FPGA |
- |
- FPGA |
XILINX FPGA (XC3SD1800A, CSG484 package), 1,800K gates |
- DDR2 |
W9725G6JB-25 (Winbond), 32 MB |
- EEPROM |
M95512-RMN6TP (ST Micro), 512 KB |
- Konfiguration EEPROM |
M25P80-VMP6G (Micron), 8 MB |
Abmessungen |
50 (W) x 50 (H) x 53.5 (D) mm excluding connectors |
Optischer Filter |
IR cut filter on |
Genauigkeit des optischen Zentrums |
Positional accuracy in H and V directions: +/- 0.3 mm
Rotational accuracy of H and V: +/- 1.5 deg.
|
Material |
Aluminum (AC) |
Objektivanschluss |
C mount |
Konnektoren |
RJ45 connector
Power/IO connector: HR10A-10R-12PB (Hirose) or equivalent
DC IRIS lens connector: M1951 (EMUDEN) or equivalent |
Kamerabefestigungsschrauben
|
Two ¼” Tripod screw holes (one on each top and bottom plate)
Sixteen M4 screw holes (Four on each top, bottom and both side plate)
|
Gewicht |
Approximately 170g |
Betriebstemperatur |
|
- Minimum |
Environmental temperature -5 deg. C |
- Maximum |
Camera housing temperature (Top plate): 70 deg. C
(See Operational temperature and Power Consumption)
|
Lagertemperatur |
-30 ~ 65 deg. C |
Vibration |
20 Hz to 200 Hz to 20 Hz (5 min. /cycle), acceleration 10G, 3 directions 30 min. each |
Erschütterung |
Acceleration 38G, half amplitude 6 ms, 3 directions 3 times each |
Normenkonformität |
TBD |
RoHS |
RoHS Compliant |